矿热炉炉壳安装作业危险性分析

为减少事故损失,必须对矿热炉安装施工危险源进行分析。基于此,对矿热炉安装工序中最重要工序炉壳安装应用作业危险性分析进行分析。将炉壳安装作业分成3大部分,用鱼刺图分析方法进行分析,总结出矿热炉炉壳安装中事故发生的主要原因并提出对策措施,以预防和减少事故的发生。     

基于短时傅里叶变换的干扰信号识别方法

目的提高无线电引信识别欺骗式干扰的能力。方法根据炮弹弹体自旋的特点,使得采用连续波线极化天线的无线电引信所收到的干扰信号呈现出有别于地面回波的周期性幅度调制特征,通过对此特征进行短时傅里叶变换后进行识别,可以作为无线电引信是否受到欺骗式干扰的判断依据。结果通过仿真和试验对方法的可行性进行了验证,表明该识别方法可以很好地提高连续波无线电引信的识别欺骗式干扰的能力。结论基于短时傅里叶变换检测旋转调制的对地旋转弹无线电引信欺骗干扰识别的方法可以对干扰信号特征进行识别,算法处理时间短,能够作为引信是否受到干扰的一种判断依据。     

温差拉深法在制造大型杯形件中的应用

用温差拉深法制造大型杯形件毛坯,可避免毛坯拉断和起皱,最大限度地降低拉深系数、减少拉深次数、降低加工成本。     

腕足类生物壳体在沉积、成岩过程中同位素平衡问题研究

综合分析了现代腕足类生物壳体方解石中的C、O同位素特征，以及有关古生代腕足类生物壳体方解石构造和地球化学研究成果，分析结果证明：只有那些无发光性特点、无胶结和溶蚀构造特点、有较好纤维构造特点、含高Sr、Na和低Mn、Fe（Mg）的第二层腕足类生物壳体方解石的δ18O值不受成岩作用影响；而原始层和壳体中的特殊部位如铰合轴、腕骨、茎孔、交互面、肌痕等在沉积、成岩过程中与海水处于非同位素平衡状态。     

显像管玻壳铅尘污染特性的研究

以石家庄市显像管玻壳厂排放的铅尘为研究对象，通过在该玻壳厂周围土壤布点采样，较系统地研究了铅尘在大气和周围土壤中的迁移和转化规律，研究表明，用高斯模式能成功地预测铅尘在大气中的迁移扩散规律，玻壳厂周围土壤表层铅含量较大值出现在当地年主导风向（SSE，N）下风向，铅在土壤中的分布主要集中在0－20cm的耕作层，在20－40cm深度范围内，铅含量呈下降趋势，最大降幅达50％。     

锅壳锅炉后管板孔桥裂纹事故的分析及处理

分析了锅壳锅炉后管板裂纹产生的原因，阐述了事故发生的机理和处理方法。     

Clam shell catalyst for continuous production of biodiesel

Continuous flow transesterification of waste frying oil (WFO) with methanol for the biodiesel production was tested in a laboratory scale jacketed reactive distillation (RD) unit packed with clam shell based CaO as solid catalyst. The physiochemical properties of the clam shell catalysts were characterized by X-ray Diffraction (XRD), Brunauer–Emmett–Teller (BET), Scanning Electron Microscopy (SEM), and Energy Dispersive Atomic X-ray Spectrometry (EDAX). The effects of the reactant flow rate, methanol-to-oil ratio, and catalyst bed height were studied to obtain the maximum methyl ester conversion. Reboiler temperature of 65°C was maintained throughout the process for product purification and the system reached the steady state at 7 hr. The experimental results revealed that the jacketed RD system packed with clam shell based CaO showed high catalytic activity for continuous production of biodiesel and a maximum methyl ester conversion of 94.41% was obtained at a reactant flow rate of 0.2 mL/min, methanol/oil ratio of 6:1, and catalyst bed height of 180 mm.     

牡蛎壳生物滤池处理含盐污水中的硝化特性

采用牡蛎壳为曝气生物滤池填料,以含NaCl的生活污水为处理对象,在SBR操作条件下,系统考察进水NaCl浓度、曝气时间及进水pH值等对硝化性能的影响。结果表明,进水NaCl浓度为10~15 g/L时,平均氨氮去除率可稳定在97%以上;较高浓度NaCl对亚硝酸化菌活性影响较弱,对硝酸化菌活性影响较强,特别是在日曝气时间少于12 h时,其出水中亚硝氮的含率大于50%;当进水pH值在6~9变化时,反应器内pH值可稳定在6.5~7.5,硝化性能良好,表明牡蛎壳填料可为硝化反应提供碱度。     

新型生物质活性炭烟气脱硫研究

以农业废弃物核桃壳为原料,天然软锰矿为添加剂共混制备得到的新型生物质柱状活性炭进行烟气脱硫的性能研究.采用固定床反应器进行脱硫实验,装填活性炭质量为16 g,考察了进口SO2含量、空速、床层温度、水蒸气和氧气含量等工艺参数对活性炭脱硫性能的影响.结果表明,进口SO2含量在0.1%～0.3%(体积含量)范围内时,活性炭的穿透硫容和穿透时间随着进口SO2含量的升高而降低;空速越大,活性炭越容易穿透,较佳的空速为600 h-1;最适的床层温度为80℃,过高会降低脱硫效率;水蒸气和氧气的存在大大促进了活性炭对SO2的吸附性能,最佳水蒸气含量为10%,最佳氧气含量为10%～13%.在最佳工艺操作条件下,当进口SO2含量为0.2%时,活性炭穿透硫容为252 mg.g-1,穿透时间可达26 h.     

Waste oyster shell as a kind of active filler to treat the combined wastewater at an estuary

Estuaries have been described as one of the most difficult environments on Earth. It is difficult to know how to treat the combined wastewater in tidal rivers at the estuary, where the situation is very different from ordinary fresh water rivers. Waste oyster shell was used as the active filler in this study in a bio-contact oxidation tank to treat the combined wastewater at the Fengtang Tidal River. With a middle-experimental scale of 360 ma/day, the average removal efficiency of COD, BOD, NH3-N, TP and TSS was 80.05%, 85.02%, 86.59%, 50.58% and 85.32%, respectively, in this bio-contact oxidation process. The living microbes in the biofilms on the waste oyster shell in this bio-contact oxidation tank, which were mainly composed of zoogloea, protozoa and micro-metazoa species, revealed that waste oyster shell as the filler was suitable material for combined wastewater degradation. This treatment method using waste oyster shell as active filler was then applied in a mangrove demonstration area for water quality improvement near the experiment area, with a treatment volume of 5 × 10^3 m^3/day. Another project was also successfully applied in a constructed wetland, with a wastewater treatment volume of 1 ×10^3 m^3/day. This technology is therefore feasible and can easily be applied on a larger scale,